Course 1 - Micrologix Programming
1.1 Objective
1.2 Exercise – Creating a Program
1.3 Exercise – Defining I/O Configuration
2.1 Objective
2.2 Exercise – OTE, XIC, XIO
2.3 Exercise – Adding Address Descriptions and Symbols
2.4 Exercise – RSLogix 500 View Properties
3.1 Objective
3.2 Exercise - Programming with Symbols
3.3 Exercise – Branches
3.4 Exercise – Adding Motor Seal-in Circuit
3.5 Exercise – Add Latches (OTL, OTU)
3.6 Exercise – Rung Comments and Page Titles
3.7 Exercise – Advanced Diagnostics
4.1 Objective
4.2 Exercise – Downloading to the Processor
4.3 Exercise – Going Online
4.4 Exercise – Processor Modes
4.5 Exercise – Program File Online Monitoring
4.6 Exercise – Data File Online Monitoring
4.7 Exercise – Project Organization
5.1 Objective
5.2 Exercise – Introduction to Timers and Counters
5.3 Exercise – TON, CTU and RES
6.1 Objective
6.2 Exercise – Add and Subtract with Registers
6.3 Exercise – Add and Subtract with Registers and Constants
7.1 Objective
7.2 Exercise – GTR, GEQ, LES, LEQ, EQU, NEQ
8.1 Objective
8.2 Exercise – Adding and Subtracting with One-shots
8.3 Exercise – Parking Lot, Part 1
9.1 Objective
9.2 Exercise – Introduction to Multiplying and Dividing
9.3 Exercise – Multiply and Divide with Registers and Constants
9.4 Exercise – Parking Lot, Part 2
10.1 Objective
10.2 Exercise – MOV
11.1 Exercise - Traffic Light, Part 1
11.2 Exercise – Traffic Light, Part 2
12.1 Project - Bottling Line
12.2 Project – Lumber Yard