What is the different between panel builder 12 and rs view32
  •  rwhite
  • 100% (Exalted)
  • Advanced Member

I assume you mean the Panelbuilder 1200? That software is used to configure the older panelview HMI units from Allen Bradley. RSView32 is Rockewell's older (but still supported) SCADA system designed to run on PC's. So the Panelbuilder software is used to configure programs for a specific piece of equipment and the RSView32 is designed to as a piece of software to be run on a PC.

The newer Rockwell platorm Factory Talk, is designed to take the place of both pieces of software you asked about but will only interface with more recent versions of the Panelview (I think it has to be a panelview plus). There is a machine edition version of Factory Talk for the panelview and a full blown version that is a SCADA.
RSLogix500 Introduction
RSLogix500 Inserting Instructions
RSLogix500 Opening a File
RSLogix500 Creating a Project
RSLogix500 Instruction Comments
RSLogix500 Rung Comments Page Titles
RSLogix500 Inserting Branches
RSLogix500 Program Organization, Part 1 - Overview
RSLogix500 Program Organization, Part 2 - Examples
RSLogix500 Using Symbols
RSLogix500 View Properties
RSLogix500 Online Offline
RSLogix500 Dowloading and Uploading
RSLogix500 Processor Modes
RSLogix500 Processor and Cards
RSLogix500 Forcing I/O
RSLogix500  Custom Data Monitor
RSLogix500 I/O Configuration
RSLogix500 Advanced Diagnostics
RSLogix500 Instructions OTL OTU, Part 1
RSLogix500 Instructions OTL OTU, Part 2
RSLogix500 Instructions OTL OTU, Part 3
RSLogix500 Instructions, OTE
RSLogix500 Instructions, XIC XIO
RSLogix500 Instructions, CTU CTD - Part 1
RSLogix500 Instructions, JSR and RET
RSLogix500 Instructions, TON - Part 1
RSLogix500 Instructions, TON - Part 2
RSLogix500 Instructions, TON - Part 3