Zackbo
  •  Zackbo
  • 59.18164% (Neutral)
  • Member Topic Starter
2020-04-30T21:28:07Z
I have a Yaskawa F7 drive that is currently being controlled only by a discrete start/stop signal. The frequency/speed is manually adjusted from the keypad. What are my options to communicate with the drive if I wanted to control the speed automatically, or monitor current?
Camber
2020-04-30T21:28:49Z
I've had the priveledge of working with a few Yaskawa drives, and I know that almost all of them are a Modbus slave out of the box (2 or 4-wire, RS485). I know for sure that the F7 is. You can also get add-on cards; I know of EthernetIP/Modbus TCP, Devicenet, and Profibus. The add-on cards run about $4-500. This would give you access to pretty much everything, even drive parameters. You could start/stop, control frequency/speed, and monitor current remotely.
RSLogix500 Introduction
RSLogix500 Inserting Instructions
RSLogix500 Opening a File
RSLogix500 Creating a Project
RSLogix500 Instruction Comments
RSLogix500 Rung Comments Page Titles
RSLogix500 Inserting Branches
RSLogix500 Program Organization, Part 1 - Overview
RSLogix500 Program Organization, Part 2 - Examples
RSLogix500 Using Symbols
RSLogix500 View Properties
RSLinx
RSLogix500 Online Offline
RSLogix500 Dowloading and Uploading
RSLogix500 Processor Modes
RSLogix500 Processor and Cards
RSLogix500 Forcing I/O
RSLogix500  Custom Data Monitor
RSLogix500 I/O Configuration
RSLogix500 Advanced Diagnostics
RSLogix500 Instructions OTL OTU, Part 1
RSLogix500 Instructions OTL OTU, Part 2
RSLogix500 Instructions OTL OTU, Part 3
RSLogix500 Instructions, OTE
RSLogix500 Instructions, XIC XIO
RSLogix500 Instructions, ADD
RSLogix500 Instructions, CTU CTD - Part 1
RSLogix500 Instructions, CTU CTD - Part 2
RSLogix500 Instructions, CTU CTD - Part 3
RSLogix500 - Comparison - Part1
RSLogix500 - Comparison - Part 2
RSLogix500 Instructions, SUB
RSLogix500 Instructions, JSR and RET
RSLogix500 Instructions, TON - Part 1
RSLogix500 Instructions, TON - Part 2
RSLogix500 Instructions, TON - Part 3