Contact Us | (123) 456-7891

RSLogix500 Course 1 - Introduction to PLC Programming

Course 1 - RSLogix500 / SLC500 Programming

1.1         Objective
1.2         Exercise – Creating a Program
1.3         Exercise – Defining I/O Configuration
2.1         Objective
2.2         Exercise – OTE, XIC, XIO
2.3         Exercise – Adding Address Descriptions and Symbols
2.4         Exercise – RSLogix 500 View Properties
3.1         Objective
3.2         Exercise - Programming with Symbols
3.3         Exercise – Branches
3.4         Exercise – Adding Motor Seal-in Circuit
3.5         Exercise – Add Latches (OTL, OTU)
3.6         Exercise – Rung Comments and Page Titles
3.7         Exercise – Advanced Diagnostics
4.1         Objective
4.2         Exercise – Downloading to the Processor
4.3         Exercise – Going Online
4.4         Exercise – Processor Modes
4.5         Exercise – Program File Online Monitoring
4.6         Exercise – Data File Online Monitoring
4.7         Exercise – Project Organization
5.1         Objective
5.2         Exercise – Introduction to Timers and Counters
5.3         Exercise – TON, CTU and RES
6.1         Objective
6.2         Exercise – Add and Subtract with Registers
6.3         Exercise – Add and Subtract with Registers and Constants
7.1         Objective
7.2         Exercise – GTR, GEQ, LES, LEQ, EQU, NEQ
8.1         Objective
8.2         Exercise – Adding and Subtracting with One-shots
8.3         Exercise – Parking Lot, Part 1
9.1         Objective
9.2         Exercise – Introduction to Multiplying and Dividing
9.3         Exercise – Multiply and Divide with Registers and Constants
9.4         Exercise – Parking Lot, Part 2
10.1       Objective
10.2       Exercise – MOV
11.1       Exercise - Traffic Light, Part 1
11.2       Exercise – Traffic Light, Part 2
12.1       Project - Bottling Line
12.2       Project – Lumber Yard